proof receiver_drum_clean rdc Trendsetter_400/800_Proofing Set to 1 to clean the emulsion side of a receiver after it has been loaded on the drum. Set to 0 to not clean the receiver after it has been loaded. byte

0

0 to 1 (no units)

Cleaning the receiver helps remove dust artifacts, but it does add about 30 seconds to a proofing image and may (very rarely) cause the receiver or carrier plate to be lifted from the drum. So keep this parameter at 0 unless the machine is experiencing to many dust artifacts. cfg

../nvs/alproof_cfg_tri.xmlNVS: alproof tri

../nvs/proof_cfg_rlc.xmlNVS: proof rlc

..\..\ShowAllErrors.htmFirmware 0 Error Index

..\..\ShowAllCommands.htmFirmware 0 Command Index

..\..\ShowAllNVS.htmFirmware 0 NVS Index

Updated: Wed Jul 16 19:37:26 2008 PST